How to drape a Nivi saree
Published
The Nivi is the drape most people picture when they hear the word saree. The fabric is pleated at the front and wrapped once around the waist, with the pallu over the left shoulder. This guide covers where the style comes from, what to have ready, and the four steps of the drape.
Where the Nivi comes from
Writers link the drape to the Deccan, and in particular to Andhra Pradesh. Nobody knows for certain how it got its name.
Its modern form is credited to Jnanadanandini Devi, the wife of Satyendranath Tagore, who popularised it in the mid-nineteenth century. She paired the drape with a blouse and petticoat. She also took ideas from the way Parsi women wore the gara, moving the pallu to the left shoulder. She went on to teach the style to other women through a women's magazine, the Bamabodhini Patrika. After Independence in 1947 the Nivi was taken up across India, and today it is the drape many women wear for work, festivals and weddings alike.
What you need
- A saree. The guide below assumes a standard length of six yards.
- A petticoat in the saree's base colour. Choose satin under sheer fabrics such as chiffon or net, and cotton under cotton or silk sarees. Tie it snugly at the waist, because it holds every tuck that follows.
- A fitted blouse.
- Safety pins, a few medium and one large.
- The shoes you plan to wear. Put them on before you start. The hem length depends on them.
Step 1: Tuck and wrap
Find the plain end of the saree, the end without the decorated pallu. Tuck its top corner into the petticoat on the right side of your waist.
Check the hem. It should just touch the floor and cover your shoes. Then wrap the saree once around your waist, tucking the top edge in as you go, until you are back at the right side.
Step 2: Place the pallu
Bring the rest of the fabric round to the front. Take the pallu end up across your body and over your left shoulder, so that it falls down your back. A pallu that reaches the back of the knee is a good length to aim for.
Pin the pallu to the shoulder of your blouse. This keeps it in place while you work on the pleats.
Step 3: Make the pleats
You now have a length of loose fabric between your waist and the pallu. Gather it into pleats at the front, each one 4 to 5 inches wide. Most sarees give six to eight pleats. The exact number depends on the saree's length and your waist.
Hold the pleats between your thumb and little finger to keep the folds even. When they are gathered, give them a gentle shake so they hang straight down to the floor.
Step 4: Tuck and secure
Tuck the top of the pleats into the petticoat, slightly to the right of your navel, so that the folds open towards your left. Fasten them from inside the petticoat with the large safety pin. They will then stay put while you walk or sit.
Finally, check the whole drape in a full-length mirror. The hem should be level all round and the pleats should fall straight. The border should run neatly along the pallu.
In the gallery
Powder-blue chiffon saree with satin blouse on the beachA long, light pallu over the left shoulder, as in Step 2. It shows how a sheer fabric falls when draped over a satin-finish blouse.
Pink saree with sheer pallu raised in the breezeThe pleated lower drape from Step 3 falls straight to the ground.